Winnebago Brave 36M Operator's Manual download pdf (Page 85)

8-3

SECTION 8

APPLIANCES & INTERIOR FEATURES

AUTO indicator and the LP GAS indicator

will illuminate. After 10 seconds, the LP

GAS indicator will turn off and only the

AUTO indicator will remain illuminated.

Press and quickly release any button to dis-

play the operating mode.

During operation in the AUTO mode, when

a higher priority power source becomes avail-

able, the operating controls will cease using the

current power source and will switch to the

higher priority power source. For example, if

AC electric becomes available while the refrig-

erator is operating in the AUTO LP GAS mode,

the refrigerator will switch to AUTO AC opera-

tion.

If an operating mode is not functional, its

corresponding indicator will flash and the refrig-

erator will attempt to operate in a lower power

priority source. If a lower power priority source

is not available, the indicator will continue to

flash, and the refrigerator will cease operation

until the energy source is corrected. Refer to the

“Diagnostic” section on page 7 of the “Norcold

9100 Series Refrigerators Operator’s Guide” in

your blue binder.

Start-Up Instructions - Manual Mode

To operate the MANUAL mode, press and

hold the MODE button until the AUTO indicator

disappears and the desired operating mode is

displayed. If the power source is interrupted

while operating in the MANUAL mode, the

AUTO indicator disappears and the desired

operating mode is illuminated. Unlike AUTO

mode, the operating mode indicator remains

illuminated until an alternate mode is selected. If

the energy source is interrupted while in the

MANUAL mode, the corresponding indicator

flashes, and the refrigerator ceases operation

until an alternative energy source is selected or

the problem is corrected. Refer to the “Diagnos-

tics” section on page 7 of the Norcold Operator’s

Guide in your blue binder for corrective actions.

AUTO and MANUAL Modes - Gas

Operation Only

If the gas does not ignite within 30 seconds,

which may occur on initial start-up, the refriger-

ator’s gas valve will automatically close and the

operating controls will select an alternate power

source (AUTO Mode) or revert to a stand-by

mode in which the LP GAS indicator flashes.

The indicator continues to flash until the refrig-

erator is turned OFF and then ON. If the gas

does not ignite after several attempts, check the

input gas supply, or consult with your dealer or a

Norcold authorized service center. A different

mode of operation may be selected by pressing

and holding the MODE button. The refrigerator

will not switch to the new operating mode until

the MODE button is released.

Backup Operating System (“BOS”)

Your refrigerator features a Backup Operat-

ing System which keeps the refrigerator cool in

the event of a failure of the refrigerator’s operat-

ing controls. If a failure occurs, the TEMP SET

indicator flashes and refrigerator switches to the

BOS mode. This mode provides refrigeration

until the refrigerator is serviced. The fresh food

and freezer compartment temperatures should be

monitored to prevent over-freezing or thawing of

refrigerator contents when operating in the BOS

mode. If the refrigerator temperature is too cold,

adjust the thermostat to a lower number in single

increments. If the refrigerator temperature is too

warm, adjust the thermostat to a higher number

in single increments. Let the refrigerator operate

at the new setting for one hour before rechecking

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 127 128

Comments to this Manuals

No comments

Winnebago Brave 36M Operator's Manual Page 85

Comments to this Manuals