Winnebago Brave 34D Owner's Manual Page 90

  • Download
  • Add to my manuals
  • Print
  • Page
    / 130
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 89
SECTION 8
APPLIANCES & INTERIOR FEATURES
8-8
Hood Fan and Light Switches
To turn on the range hood light, simply press
the switch labeled “Light”. To operate the range
hood fan, press the “Fan Hi/Lo” switch.
SYSTEMS MONITOR PANEL
(Wall Mounted)
The System monitor Panel provides a conve-
nient central location for checking the condition
of all utility systems in your coach. At the touch
of a button this panel can display the fresh water
and holding tank levels, LP gas tank level, plus
coach battery condition. You can start the auxil-
iary generator or turn on the water pump and wa-
ter heater. Indicator lights tell you if the water
pump is on or if the water heater pilot light is out.
Water And Holding Tank Levels
Press and hold the “Levels Test” switch to
show approximate level on the monitor lights.
These approximate water levels are measured
by electronic probes in the sides of the tanks, so
the water must be touching a probe to register at
that level. There is generally more water in a tank
than indicated on the monitor panel.
For example, if the water level of 1-2” below
the FULL probe, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If the water level is below the 1/3 probe, the mon-
itor will register an empty tank because the water
is no longer touching the 1/3 probe. There may
actually be some water left in the tank. However,
when the indicator reads FULL, the tank is actu-
ally full.
Tank Capacities
See back of “To The Owner” page inside
front cover of this manual.
LP Gas Level
Press and hold the “Levels Test” switch to
show approximate LP tank level.
The LP level is registered by a sending unit on
the tank. The gauge mounted on the side of the
tank will give a more accurate indication of actu-
al tank level if needed.
Water Pump Switch
When use of the self-contained water system
is desired, turn the “Water Pump” switch on. The
“Pump On” light will illuminate when the pump
switch is on and the system is operable. Water
will be available as soon as a faucet is opened.
Refer to “Fresh Water System” for additional in-
formation on the water pump and initial start-up.
Page view 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 129 130

Comments to this Manuals

No comments